Do’s and Don’ts:- Precautions While Using Chain Pulley Block

www.safetygoodwe.com

The Safety Print - Safety Tales

Precautions while using Chain pulley blocks

Do….👍

• Check the structure of hook supporting the chain block has adequate strength.
• Ensure minimum Factor of Safety ‘3’.
• Ensure to isolate / barricade the work area where lifting operation is on-going
• Make sure that the load is free to move and clear all obstructions.
• Confirm that the brake is functioning properly by hoisting the load to 100mm and check the brake when lowering the load.
• Make sure all persons stay clear of the suspended load.
• Protect load chain from weld spatter or other damaging contaminants.
• Use chain blocks with hook latches.
• Regularly clean the whole length of load chain as recommended.
• Avoid swinging of load while hoisting.

Don’t…👎

• Don’t run the load chain out too far, when operated beyond the range of lift, an excessive load will be imposed on the chain block.
• Don’t lift a load in excess of safe working load of the chain block.
• Don’t walk or work under a hoisted load and never lift, support or transport people.
• Don’t leave a load hanging on the chain block.
• Don’t use damaged equipment, the same must be sent for servicing/repairing.
• Don’t lift with the point of the hook and never use the load chain as a sling by back hooking.
• Don’t operate unless load is centered under hoist.
• Don’t allow the chain or hook to be touched by a live electrical cable / welding electrode.
• Don’t adjust or repair a chain blocks unless qualified to perform.
• Don’t attempt to lengthen / modify the load chain, load hook or repair damaged load chain.