The Safety Print: Do's and Don'ts :- Safety Harness

Do's and Don'ts :- Safety Harness

Do….👍

Ensure you use an approved and registered full body type harness with the correct type of shock absorber lanyard.
Use an anchorage that is located directly above the working position.
Use approved permanent anchorage points that have been built or installed by professionals.
Use only permanent approved anchorage points
Use only approved attachment hooks that are recommended by the manufacturer.
Always ensure that the closing bar on the karabiner hook is locked shut.
Make sure that the space you would travel through in the event of a fall is free from protrusions and hazards.
Ensure that your harness is fitted as close to your body as is comfortable to prevent its upward movement in the event of a fall.
Only use compatible ancillary equipment provided by the manufacturer

Don’t…👎

Use a rope as a lanyard, a shock absorber lanyard must be used.
Anchor to a structure that can fall i.e. window cleaners cradle, free standing ladder or other loose structures
Use an anchorage point that will not take a shock load of 1000 kg.
Use an anchorage point that is below the point attachment to your harness.
Loop lanyards around structures with sharp edges, (less than 5mm or 7/32” radius edge).
If you have any doubts on any equipment DO NOT USE IT.
Extend the length of your lanyard beyond 2m. For greater working distances use a FALL ARRESTER BLOCK.

The Safety Print